Download Wiko Ufeel Prime Official Stock Rom/Firmware
This page contains the direct download link for Wiko UFeel Prime stock rom and should not be used in another device. Make sure you backup your data or files before flashing your device if not done, your files will be lost because everything on the phone's memory will be wiped out but if you use external sd card you can move your files there for safe keeping.
Wiko UFeel Prime Key Specs & Features
- 5.0-inch IPS Display, 1080 x 1920 pixels (441 ppi)
- 1.4GHz octa-core Qualcomm Snapdragon 430 CPU with 4GB RAM
- Android 6.0 (Marshmallow)
- 32GB Storage, up to 64GB memory card support
- 13MP Rear Camera and 8MP Front Camera
- 4G LTE Data
- Fingerprint Sensor (Front)
- 4000 mAh Li-Po Battery
Wiko Ufeel prime Stock Rom
[Download Stock Rom ##download##]
[Download Stock Rom ##download##]
HOW TO FLASH THIS DEVICE
- After downloading the rom file, extract the installation file to your computer’s desktop.
- Run the installation software as administrator.
- If prompted, click on “OK” to start rebooting your computer into safe mode. For Windows 7 only.
- For Windows 8/10, if necessary:
- – Disable driver signing
- – Turn Windows Firewall on or off
- Launch the update software by selecting Run as Administrator.
- Phone powered off, press on Volume up and Vvolume down, then connect the phone to the computer via a USB cable, hold the two buttons until the software starts downloading.
- Please wait a few minutes so that the drivers will install correctly before clicking on the ‘Download’ button. You can check the progress of the driver installation by clicking on the installation icon in the taskbar(at the bottom right of your screen).
- Qualcomm HS-USB QDloader Loader drivers should now install.
- Then click on the ‘Download’ button
- The update process will begin and would show 100% when it’s completed.
- You can now disconnect your phone from the PC and power it on.
COMMENTS